Power Commander 3 Full Install (Part 2 Installation)

 

Part two of this series runs you through the install process I took to get my PCIII in my bike. As you will see there is not much to it but there are a few things to remember when performing this diy which I have outlined below.

*Never pull from the wires of any of the connectors.
*Make sure you always check and insure you have the black connector of the PCIII in the right orientation.
*Always listen for that CLICK sound when making your connections
*It doesn't matter what side you run the PCIII harness on. The right side had more room for me cable wise and made connecting the battery ground easier.
*Use a "RED" T-Tap and don't kill it when crimping it closed.
*The TPS signal wire color is PINK with a BLACK STRIPE.

All information about making on the fly adjustments using the 3 buttons on the front of the PCIII can be found on the download section of the power commander website. You can also find a guid on this site relating to the 3 button configuration I took if your interested.

Power Commander 3 Full Install  (Part 2 Mapping to Installation)