Power Commander 3 Full Install (Part 1 Mapping)
There are many reason why you may be thinking about
purchasing a Power Commander. Increased horsepower, fine tuning your racing
machine, addition of some aftermarket parts or maybe you just want to dive
deeper into your knowledge. ALL ARE VERY GOOD REASONS.
As for me I recently purchased a new motor with 1,600 miles
on it. With my previous bolt-on mods of a Yoshi Exhaust and K&N Air filter
this made my new engine run lean, thus making the exhaust piping extremely hot (more
to it than that but you get what I'm saying). With heat pouring out from the
piping this made street riding unbearable. In fact the heat was so bad that it
began to warp my cheap Chinese fairings and discolor/bubble my paint.
Now, don't get what I’m saying about heat confused. The
pipes were heating up due the lean condition, not the engine, the engine ran at
its normal operating temp and never overheated. The only way to richen out a
lean condition is with a fuel manager such as a PC3.
2020 UPDATE
For those of you looking to download a map for your motorcycle Dyno Jet has updated their website and you must NOW register in order to see any maps. Once you have registered with the site, log in and go to https://www.dynojet.com/tunes and put in your bikes information in the 5 boxes located just under the picture titled "Tunes" and click go.
Your bikes maps should populate and under the downloads column you should see
the maps for you modifications. If you see login in this section then you are
not logged in and must do so.
For my 600 folks looking for a map you will find it under
"Power Commander" dropdown AND NOT "Power Commander III
USB". The pages are limited to only 10 maps per view and there is a total
of 3 pages, so if you don't see your map on the first page be sure to go
through all 3 pages.
Power Commander 3 Full Install (Part 1 Mapping)
Products Used in this Video
Alligator Clips: https://amzn.to/3hScyWr
Breadboard Jumper Leads: https://amzn.to/3ffntb9
9 Volt Battery Snap: https://amzn.to/317PVa1
0 comments: